|
2.6i ignition timing
|
|
07-16-2014, 05:37 PM
Post: #7
|
|||
|
|||
|
RE: 2.6i ignition timing
Unfortunately it's just a basic Xenon tube gun with rpm compensation.
I have now measured the pulley flange nearest the timing coverand it's about 135mm dia, so 6 degrees works out at 7mm by my maths: 135 x 3.142 = 424mm circ. 424 / 360 = 1.18 mm per degree. At least I will be able to see if it's close or miles out. Thanks again. |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
2.6i ignition timing - silverbullet - 07-16-2014, 10:04 AM
RE: 2.6i ignition timing - syncromad - 07-16-2014, 10:41 AM
RE: 2.6i ignition timing - silverbullet - 07-16-2014, 12:23 PM
RE: 2.6i ignition timing - syncromad - 07-16-2014, 02:30 PM
RE: 2.6i ignition timing - silverbullet - 07-16-2014, 03:31 PM
RE: 2.6i ignition timing - syncromad - 07-16-2014, 04:13 PM
RE: 2.6i ignition timing - silverbullet - 07-16-2014 05:37 PM
Re: 2.6i ignition timing - silverbullet - 07-16-2014, 09:35 PM
RE: 2.6i ignition timing - syncromad - 07-17-2014, 07:00 AM
Re: 2.6i ignition timing - silverbullet - 07-18-2014, 11:08 PM
|
User(s) browsing this thread: 1 Guest(s)